Adaptation of the dispenser and lifts after changing the pusher/tray from spirals to conveyor belts or sideshifters
Note: After the spirals have been replaced with conveyor belts, the following settings should be made:
1. navigate to the item "Set Drive Board" (located under the item "Item&Slot")
2. make settings.
Here you can set which slots should work with Spring (spiral) and which slots should work with Belt/Sidepush (conveyor belt/side pusher).
Example: You change all spirals with conveyor belts. Then you have to type in "255" at "Set Slot" -> Work in Belts (line 3) and save. "255" converts all slots and the machine now knows that conveyor belts are installed instead of spirals.
Lift adjustments
1. open the developer menu.
Instead of the admin password, enter the following password: 80515.
Entering this code will take you to the developer menu. Please do not change any settings there, except for the following!
Navigate to item 10 Slot Motor Work Mode.
2. select the desired output method.
Enter the Start Slot and End Slot as well as the respective output method. Save, done.